Instructions / Assembly

Assembly InstructionsAssembly Instructions

Parts List

Screw the Leveling Feet (C) into the bottom of a Pole (B). Snap the Plastic

Clips (D) into the pole grooves of a Pole (D) at the same position and

make sure that the arrow of plastic clips are pointing up.

Please make sure that you have the wire shelf (A) the correct way up. (The

gap in collar shall be faced down) Hold the shelf on its side and slide the top

of four lower poles through the bottom of each shelf at its corners until there

is a snug fit. After 4 poles have been

slid through the shelf collar holes,

set the shelf upright.

Keep the gap in collar face down

Raise Lower

Plastic Clips’ arrow

should point up

Refer to Step 1 to snap the Plastic Clips (D) on the grooves of four Poles (B)

at your desired position and slide the Wire Shelf (A) down from the top of each

pole down onto the plastic clips.

*To ensure the

stability of the

shelves, make

sure all 4 clips are

attached to the

same layer on

the pole.

Apply the Shelf Liner (E) onto the top of each Wire Shelf (A).

Push firmly down on every wire shelf at its corners atop the Shelf Liners (E)

with a rubber mallet to ensure all the shelves are properly in place over the

plastic clips. To attain proper leveling, screw the leveling feet inwards

or outwards.

Continue to build 2 additional layers with by snapping Plastic Clips (D) on the

same grooves of each Pole (B) and installing the Wire Shelves (A).

Shelf Liner