User guide

Display and Controls18 EFAS
22
2.3.1 Adjusting of the Activity
The following activities are indicated by the digital tacho-
graph EFAS:
 Driving time (set automatically)
 Working time
 Availability
 Rest time
Manual setting
• As driver in stationary vehicle press the button 1 so
often, until the desired activity (
, , ) appears in the
display. On this occasion, take care that the button is
not pressed too long, as this will eject the card.
• Press, as co-driver (driver 2), the button 2, so often
until the desired activity appears in the display.
Activity driver 1 Activity driver 2
Note
Do not forget to check the set activity after the journey end.
Automatic adjusting of the Activity
After the vehicle starts to move the digital tachograph EFAS
switches, after a short time, automatically for the driver to
driving time  and for the co-driver to availability . If the
vehicle stops, the digital tachograph EFAS toggles, for the
driver, automatically to working time .
In addition to the above mentioned change-over of the
driver's activity, the digital tachograph EFAS takes back the
automatic switchover of driving time to working time again if
the vehicle stops for less than 2 minutes.
If the automatic switchover of the activity is activated after
ignition ON/OFF, the driver and/or the co-driver receives
the preset activity if the ignition is switched on or switched
off. This setting can be carried out with an inserted com-
pany card with the menu “Settings“, see "Automatic Setting
of Activities after Ignition OFF/ON" on page 58.