User guide

Operation of EFAS – Driver and Co-Driver28 EFAS
3
If you do not want to end the shift, use the cursor keys 
 and to select NO and press OK. Your driver card will
be ejected.
5. Withdraw the tachograph card of the co-driver, if
necessary
. Press key 2 for longer than 1.5 seconds to
withdraw the card.
The driver card of the co-driver is ejected.
6. Insert the driver card of the n
ext driver into the left-
hand card slot.
The card data is read. For more information, see the
section "Before Starting" on page 25.
7. Insert the driver card of the future co-driver into the
rig
ht-hand card slot. The card data is read in. The
entries are now complete. You are ready to go.

3.4 Stopping, Withdrawing the Driver Card
Withdraw your driver card from the digital tachograph when
ending your journey or when interrupting it for a longer time
outside of the vehicle.
Note
Always keep your tachograph card in a safe place in a protective
cover. Do not leave the tachograph card on the dashboard.


Note
If the special condition „OUT of scope“ (digital tachograph not
required) is active, the condition is automatically switched off
after withdrawal of the driver card.
Stopping the Journey
1. Park your vehicle. Leave the ignition on.
2. Withdraw the driver card. Press key 1 fo
r longer than
1.5 seconds to withdraw the card.
The display asks for the cou
ntry where your journey
ends.
3. Use the cursor keysand to select the country
whe
re your journey ends. Press OK. The list of
country codes is shown in the section "Nation &
Region Codes, Time Zones" on page 119. When
selecting Spain, the region must also be selected.
or
Ignore this input by pressing the key .