User guide

Messages 77© by EFKON AG
8
8.3 Printout Messages
Display Meaning
There is no paper in the printer. Insert a new reel of paper. For more information, see the section
"Inserting a Reel of Paper" on page 44. When a new reel of paper has been inserted, printing
automatically resumes.
The temperature inside the printer is too high or too low.
Wait until the printer has cooled down or the printer has warmed up. Then start printing.
The printer is only active when the ignition is on.
A running printout is halted if the ignition is switched off. Turn on the ignition again within 30 seconds
to resume the printout automatically. Otherwise the printout is cancelled.
You removed the printer module from the digital tachograph.
This terminates printing. Remove the printer module only when the display shows Paper empty.
The vehicle started moving while printing was underway (here: daily reports from card). 
Printing is terminated. Stop the vehicle and restart printing.
No data available for selected printout. This message may occur e.g. for printout type „D1/D2 status
changes“ if no signal changes were recorded.