Use and Care Manual

56V LITHIUM-ION CORDLESS CHAIN SAW — CS160014

Use only with the battery packs and chargers listed below:
BATTERY PACK CHARGER
BA1120, BA1400, BA2240
BA2800, BA4200
CH2100
CH5500

Do not charge the battery pack in rain or in wet locations.

Plan the work, ensuring an obstacle-free work area and, in the case of
felling, at least one escape path from the falling tree.

When felling, keep bystanders at least two tree lengths away.

If situations occur which are not covered in this manual, use care and
good judgment. Contact EGO Customer Service for assistance.
KICKBACK SAFETY DEVICES ON THIS CHAIN SAW
Chain Brake
The chain saw comes equipped with a chain brake, which stops both the motor and
the motion of the chain when kickback occurs. The chain brake can be activated by
the forward motion of the chain kickback brake handle as the saw rotates backward
during kickback; it can also be activated by the inertial forces generated during rapid
pushback.
WARNING
: Never modify or attempt to disable the chain brake.
Make sure that the chain brake is working properly before using the chain saw. The
chain kickback brake handle should move back and forth easily.
To test the operation of the chain brake,
perform the following steps (Fig. 6):

Place the chain saw on a at bare
surface and make sure no objects
or obstructions that could come in
contact with the bar and chain are
in the immediate vicinity.

Disengage the chain brake by
pulling the chain kickback brake
handle towards the front handle.
6
Chain kickback brake
handle in operating position
Chain kickback brake
handle in brake position