Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC10
Stop the blade when crossing gravel drives, walks or roads.
If the equipment should start to vibrate abnormally, immediately stop the motor,
remove the battery and check for the cause. Vibration is generally a warning of
trouble.
Before cleaning the machine, unclogging the chute or removing or replacing the
grass bag, mulching insert, or side discharge chute, turn the motor off and wait
until the blade comes to a complete stop, then remove the battery pack. The cutting
blade continues to rotate for a few seconds after the motor is shut off. Never place
any part of the body in the blade area until you are sure the blade has stopped
rotating.
Never operate the mower without the proper trailing shield, discharge cover, grass
bag, mulching insert, side discharge chute, motor/blade control handle or other
safety protective devices in place and working. Never operate the mower with
damaged safety devices. Failure to do so can result in personal injury.
If situations occur that are not covered in this manual, use care and good judgment.
Contact EGO Customer Service for assistance.
Use only with the battery packs and chargers listed below:
BATTERY PACK CHARGER
BA1120, BA1120-FC, BA1400,
BA1400-FC, BA2240, BA2240-FC,
BA2800, BA2800-FC, BA4200,
BA4200-FC
CH2100, CH2100-FC,
CH5500, CH5500-FC
OPERATION ON A SLOPE:
Slopes are a major factor related to slip-and-fall accidents, which can result in severe
injury. Operation on slopes requires extra caution. If you feel uneasy on a slope, do
not mow it. For your safety, use the slope gauge on page 22 to measure slopes before
operating this unit on a sloped or hilly area. If the slope is greater than 15 degrees, do
not mow it.
Do:
Mow across the face of slopes; never mow up and down. Exercise extreme caution
when changing direction on slopes.
Watch for holes, ruts, rocks, hidden objects, or bumps which can cause you to slip
or trip. Tall grass can hide obstacles.