Use and Care Guide

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC 49
Problem Cause Solution
The mower
stops while
mowing
◾
The battery pack is depleted.
◾
Mower is in overload condition.
◾
Mower deck is clogged with
grass and debris.
◾
The battery or mower circuitry is
too hot. (The power indicator on
the mower will illuminate orange
for 10 seconds.)
◾
The side rail is retracted a little
by the pushing force applying on
the handle.
◾
Charge the battery pack.
◾
Raise the cutting height or slow
down the mowing.
◾
Unclog the mower deck. Raise
the cutting height, or cut a
narrow swath.
◾
Allow the battery pack or mower
to cool until the temperature
drops below 152°F (67°C).
◾
Unlock the clamps. Fully extend
the side rails and lock the
clamps agai
n.
The mower
does not
mulch properly
◾
Wet grass clippings are sticking
to the underside of the deck.
◾
The mower is set to cut too much
grass at once.
◾
Wait until the grass dries before
mowing.
◾
Raise the deck to a higher
cutting height setting.
There is
excessive
vibration
◾
The cutting blade is loose.
◾
The cutting blade is unbalanced.
◾
The cutting blade is bent.
◾
The motor shaft is bent.
◾
Tighten the blade bolt.
◾
Balance the blade following the
instructions.
◾
Replace the blade.
◾
Contact the service center.
The handle-
locking clamps
cannot be
closed in
position
◾
The side rails are not fully
extended.
◾
Fully extend the side rails, then
lock the clamps.