Use and Care Guide

POLE SAW ATTACHMENT — PSA100032

TRANSMISSION GEARS LUBRICATION

The transmission gears in the gear case need be lubricated periodically with gear

grease. Check the gear case grease level about every 50 hours of operation by

removing the sealing screw on the side of the case.

If no grease can be seen on the sides of the gear, follow the steps below to ll with

gear grease up to 3/4 capacity.

Do not completely ll the transmission gear case.

1. Position the pole saw attachment on

its chain-sprocket cover side on a

rm, at surface, so that the sealing

screw is facing upwards (Fig. 28).

2. Use the dual-head wrench provided

to loosen and remove the injection

screw.

3. Use a grease syringe (not included)

to inject some grease into the screw

hole, taking care not to exceed 3/4 capacity.

4. Tighten the sealing screw after injection.

TRANSPORTING AND STORING

1. Do not store or transport the pole saw attachment when it is running. Always

remove the battery pack before storing or transporting.

2. Always place the guide bar sheath on the guide bar and chain before storing or

transporting the pole saw attachment. Use caution to avoid the sharp teeth of the

chain.

3. Clean the pole saw thoroughly before storing. Store the pole saw indoors, in a dry

place that is locked and/or inaccessible to children.

4. Keep away from corrosive agents such as garden chemicals and de-icing salts.

Sealing Screw

Gear Case