Use and Care Manual

56-VOLT POWER INVERTER12
2. Connect the small USB or AC device to the power inverter.
3. Press and hold the power button until the green light in the button illuminates.
The power inverter will begin charging the device.
4. When not using or after charging, disconnect the device from the power inverter,
then press and hold the power button until the green light turns off.
5. Hold the battery pack with one hand and pull the power inverter with the other
hand to separate them.
WARNING: Always be aware of the location of your feet and children or pets
around you when separating the battery pack from the power inverter. Serious injury
could result if the battery pack falls. NEVER remove the battery pack at a high location.
WARNING: Do not insert a nail, wire, etc. into the AC power supply port, or the
risk of electric shock may occur.
NOTE:
 The product may not supply power to some USB devices.
 Do not insert a nail, wire, etc. into the USB power supply port. Otherwise a circuit
short may cause smoke and re.
 If the devices connected to the power inverter draw more than the rated output
of the ports (Total 4.2A for USB ports and maximum 150W for AC port), the power
inverter will shut off automatically and the power button will ash red. In this
situation, devices should be removed. To reactivate the power inverter, press and
hold the power button until green light is illuminated.
 When switching on the power inverter, if the USB output current is less than
500mA and the AC output power is less than 5W, the system will shut off
automatically in 1 minute.
 When switching on the power inverter, if the USB output current is beyond 500mA
or the AC output power is beyond 5W, but then the USB output current is less than
500mA and the AC output is less than 5W for 3 hours, the system will shut off
automatically.