Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER22

Wind the spool with new line

WARNING:

To prevent serious personal injury, remove the battery pack from the

tool before servicing, cleaning, changing attachments or removing material from the unit.

1. Remove the battery pack

2. Press the release tabs on the spool

base and remove the spool retainer

by pulling it straight out (Fig. 15).

3. Remove the spool. Use a clean cloth

to clean the inner surface of the

spool retainer and spool base.

NOTICE: Always clean the spool retainer

and spool base before reassembling the

trimmer head.

4. Check the spool retainer, spool and

spool base worn wear parts.

5. Take approximately 15 ft (4.5m) of

0.095 in. (2.4 mm) diameter cutting

line. Fold the line in half and then

adjust it so that one end is

4.5 in. (11cm) longer than

the other (Fig. 16).

6. Hook the folded end of the cutting

line onto either of the slots in the

spool (Fig. 17).

7. Wind the line, in two even and tight

layers, onto the spool. Wind the line

in the direction indicated on the

spool (Fig. 17).

NOTICE: Failure to wind the line in the

direction indicated will cause the trimmer

head to operate incorrectly.

4.5" (11 cm)

Winding Direction

Tab