Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER24

11. With the spool base facing

downward, align the slots in the

spool retainer with the tabs on the

spool base and press the retainer

evenly down until it snaps into place

(Fig. 21).

NOTICE: Make sure that the tabs on the

spool base snap into place or the spool

will come out during operation.

Install a pre-wound spool

WARNING:

To prevent serious personal injury, remove the battery pack from the

tool before servicing, cleaning, changing attachments or removing material from the

unit.

1. Remove the battery.

2. Press the release tabs on the spool base and remove the retainer by pulling it

straight out (Fig. 15)

3. Remove the spool. Use a clean cloth to clean the inner surface of the spool

retainer and spool base.

NOTICE: Always clean the spool retainer and spool base before reassembling the

trimmer head.

4. Check the spool retainer, spool and spool base for wear. If necessary, replace the

worn parts.

5. Place a pre-wound spool on the spool retainer.

6. Align the notches of the spool from which the lines protrude with the eyelets in

the spool retainer and position the spool in the retainer (Fig. 19).

7. Hold the spool and spool retainer; grasp the line and pull it to release the line

from the notch in the eyelet (Fig. 20).

8. With the spool base facing downward, align the slots in the spool retainer with

the tabs on the spool base and press the retainer evenly down until it snaps into

place (Fig. 21).

NOTICE: Make sure that the tabs on the spool base snap into place or the spool will

come out during operation.

Tab

Slot