Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER16

MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE

WARNING:

Always remove the battery pack from the product when you are

assembling parts, making adjustments, cleaning, or when the product is not in use.

1. Remove the battery pack from the

trimmer.

2. Loosen the four screws in the

handle with the supplied hex

wrench and remove the screws and

the lower clamp from the handle

(Fig. 6).

3. Attach the front-assist handle and

lower clamp on the shaft and secure

them by pre-tightening the four

screws. Turn the front-assist handle

upwards so that it points toward the

top of the handle (Fig. 7).

4. Adjust the front-assist handle

position between the rear handle

housing and the joint of the shaft,

as shown in Fig. 7. For ST1500F/

ST1500F-FC, adjust the handle

position so that it is between the

rear handle housing and the warning label on the shaft. Shorter users may adjust

the handle to a lower position (away from you) and taller users may adjust the

handle to an upper position (towards you). The handle should be adjusted so your

front arm will be straight when using the trimmer.

5. Tighten the four screws so that the handle cannot be rotated on the shaft.

Front-Assist Handle

Lower Clamp