Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER 23

3. Cut one piece of cutting line 16 ft.

(5m) long. Insert the line into the

mounting hole, which is located

inside the eyelet. Push until the end

of the line comes out of the other

side of the spool base. Pull the

line from the other side until equal

amounts of line appear on both

sides of the spool (Fig. 15).

4. Rotate the spool retainer in the

direction of the arrow to wind

the line onto the spool until

approximately 5.5 in. (14cm) of line

is showing on each side (Fig. 16).

5. Push the spool retainer down while

pulling on lines to manually advance

the line and to check for proper

assembly of the trimmer head.

RELOAD THE CUTTING LINE, IF

NECESSARY

NOTICE: When the cutting line breaks from the line outlet or the cutting line is not

released when the trimmer head is tapped, you need to remove the remaining cutting

line from the spool retainer and follow the steps below to reload the line.

1. Remove the battery pack.

5.5" (14 cm)

Mounting Hole

inside the

Eyelet