Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER32
PROBLEM CAUSE SOLUTION
Trimmer head will
not advance line.

The motor shaft or trimmer
head is bound with grass.

Stop the trimmer, remove the
battery, and clean the motor shaft
and trimmer head.

There is not enough line on
the spool.

Remove the battery and replace the
cutting line; follow the section "LINE
REPLACEMENT" in this manual.

The trimmer head is dirty.

Remove the battery and clean the
spool, spool retainer and spool base.

The line is tangled on the
spool.

Remove the battery, remove the line
from the spool and rewind; follow
the section "RELOAD THE CUTTING
LINE" in this manual.

The line is too short.

Remove the battery and pull the
lines manually while alternately
pressing down and releasing the
trimmer head.
Grass wraps around
trimmer head and
motor housing.

Cutting tall grass at ground
level.

Cut tall grass from the top down,
removing no more than 8 inches in
each pass to prevent wrapping.
The blade is not
cutting the line.

The line-cutting blade on
the edge of the guard has
become dull.

Sharpen the line-cutting blade with a
file or replace it with a new blade.
Cracks on the
trimmer head or
the spool retainer
comes loose with
spool base.

The trimmer head is worn
out.

Replace the trimmer head
immediately; follow the section
"TRIMMER HEAD REPLCEMENT"
in this manual.
During line
replacement, the
line can’t be loaded
into the trimmer
head properly.

Spool retainer’s LOAD
lines do not align with the
eyelets in the spool base.

Rotate the spool retainer in the
arrow direction to align the LOAD
lines on the spool retainer with the
eyelets in the spool base

The string line is not
correctly inserted into
the mounting hole in the
eyelet.

Align the LOAD lines with the eyelets
first, then insert the line into the
mounting hole, which is located
inside the eyelet.