Use and Care Manual

56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER 27

7. Use circlip pliers to remove the

circlip. Remove the fan assembly

(Fig. 25).

8. Replace with a new trimmer head

and mount it in following steps.

Install the new trimmer head

1. Align the key slot in the fan

assembly with the spline in motor

shaft and mount the fan assembly

into place (Fig. 26).

2. Mount the circlip, upper cover, spool

assembly, and washer in that order.

Use an impact wrench on the nut to

tighten it.

3. Following steps 4 & 5 in “RELOAD

THE CUTTING LINE” section in this

manual to mount the lower cover

assembly.

4. Follow the instructions in “LINE

REPLACEMENT” section in this manual to reload the cutting line.

5. Start the tool to see whether the string trimmer will work normally. If it does not,

reassemble as described above.

CLEAN THE UNIT

◾

Clear any grass that may have wrapped itself around the motor shaft or trimmer head.

◾

Use a small brush or the air discharge of a small vacuum cleaner brush to clean the

air vents on the rear housing.

◾

Keep the air vents free of obstructions.

◾

Clean the unit using a damp cloth with a mild detergent.

◾

Do not use any strong detergents on the plastic housing or the handle. They can be

damaged by certain aromatic oils, such as pine and lemon, and by solvents such as

kerosene. Moisture can also cause a shock hazard. Wipe off any moisture with a soft,

dry cloth.

Fan Assembly

Circlip

Key Slot

Spline