Use and Care Manual

STRING TRIMMER ATTACHMENT—STA150020

5. Press, while rotating the spool

retainer in the direction indicated by

the arrow, to wind the cutting line

onto the spool until approximately

5.5in. (14cm) of line is showing on

each side (Fig. 10).

6. Push the spool retainer down while

pulling on the lines to manually

advance the line and to check for

proper assembly of the trimmer

head.

When the cutting line breaks from the line outlet or the cutting line is not released when

the trimmer head is tapped, follow the steps below:

1. Remove the battery pack.

2. Press the release tabs on the spool

retainer and remove the spool

retainer by pulling it straight out

(Fig. 11 & 12).

3. Remove the cutting line from the

spool retainer.

5.5” (14 cm)

Release Tab

Spool Base

Spool Retainer