Product Manual

56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200L/ZT4200L-FC46

NOTICE: one 13/16 in (21mm) wrench and one 23/32 in (18mm) wrench are required to level the cutting deck. The

wrenches are not included.

To Make Side-to-Side Adjustment

1. Postion both blades so that the ends point toward the sides of

the mower (Fig. 28).

2. On the outside edge of each blade, measure the distance

from the bottom edge of the side of the blade to the ground

(Fig. 29). If the distance between the two sides is greater than

13/64 in (5mm), side-to-side adjustment is necessary.

3. On the side you wish to adjust, use a 13/16 in (21mm) open-

end wrench (not supplied) to adjust the one jam nut on the

back of the mower (Fig. 30).

4. Measure again. Continue to adjust and measure until the

difference between the distance on each side is within 13/64

in (5mm).

5. Proceed to front-to-back adjustment or retighten the nuts.

NOTICE: in case of the jam nut on the back is removed from the

tool accidently, remount it with the shoulder of the jam nut facing

outward. No requirement for the two nuts on the suspension

linkage.

Jam Nut

The shoulder facing outward

Blades side to side

Leveling Gauge

Bottom edge of

the blade

Distance