User manual

Operating instructions

EGSTON Open Frame switch-mode power supplies

Prior to commissioning of the device, the operating instructions should be read carefully and the safety information should be

heeded

Safety information

Danger of electric shock! All models should only be installed by qualified specialist staff in accordance

with applicable regional conditions! The manufacturer is responsible for the protection of users and

specialist personnel.

An internal fuse protects the device and must not be replaced by the user. Switch off the power supply

immediately in the event of malfunction or damage.

It is the responsibility of the manufacturer to operate the switch-mode power supply according to the

limit values given in the EGSTON specification.

If provided, the earth connection for the switch-mode power supply must be connected to the protective

earth of the building wiring.

Installation

These products are intended for use in plants that have access that is restricted to specialist personnel.

Touching the components can cause an electric shock! Prior to commencing installation work,

disconnect the system from the power supply. Please ensure that it cannot be switched on again

accidentally.

Insulation distances are to be maintained on all sides of the device. The required insulation distances

can be found in the Egston specification.

Connection of the device must only be carried out using output connectors specified by Egston. (See

Egston specification). The switch-mode power supply must be connected to the mains using a max. 16

A fuse.

When fitting the Open Frame printed circuit board using screws, please refer to the Egston specification

with regard to sizes.

Please visit www.egston.com for further information on Egston products

Maintenance

This product cannot be maintained by the customer. Only EGSTON and its approved distributors are

authorised to carry out repairs.

PAGE 1
Operating instructions EGSTON Open Frame switch-mode power supplies Prior to commissioning of the device, the operating instructions should be read carefully and the safety information should be heeded Safety information Danger of electric shock! All models should only be installed by qualified specialist staff in accordance with applicable regional conditions! The manufacturer is responsible for the protection of users and specialist personnel.
PAGE 2
Intended use The switch-mode power supply must only be connected to and operated on 100–240 V AC voltage. Please take note of the input and output data stated on the device. The device is designed for IP00 and must not be exposed to any external moisture. The switch-mode power supply must only be used in an environment with contamination grade 2 and overload category II. The switch-mode power supply must not come into contact with any dust, flammable gases, vapours, solvents or benzines.