User Manual

Fields of application

For wet and drying suctioning.

Dust class M vacuum cleaners are suited to suctioning up/off dry non-

flammable dust non-flammable liquids, wood dust and hazardous dust with

AGW ≥ 0.1 mg/m

Commissioning

Switch the unit ON/OFF with the switch (2a) in the top

section (1) (or switch to automatic mode — see Section operating field).

Operating field

Depending on the unit configuration, the following functions and settings are

available:

0 = Suction unit >off<

I = Suction unit >on<

A = Ready mode for ON/OFF automatic mode.

(Suction unit is switched ON/OFF by the electrical tool)

RA = Ready mode like "A" plus automatic filter cleaning.

IR = Vacuum cleaner switched on with automatic shaker function

AR = Vacuum cleaner on standby - The vacuum cleaner only

switches on when the tool is switched on. After the tool is

switched off, the vacuum cleaner runs on for approx. 10 sec to

prevent any residue from collecting in the hose.

The power socket (2b) is available for connecting an electrical tool.

Caution! The electrical tool must be switched off during connection. The

power socket is permanently supplied with voltage when the plug is in the

mains socket regardless of the switch setting. In switch setting "0" the power

socket could still be used as an extension cable (e.g. for lights).

Connected load: Suction unit and connected unit max. 16 A.

Pre-selection switch (2d) for minimum volume signal (horn and light)

for suction units of the class "M".

In mode A, RA, IR or AR, the following settings should be made depending

on the diameter of the hose:

Hose diameter Switch setting

Ø 35 mm 70 m

Ø 27 mm 40 m

Ø 21 mm 20 m

The speed is not regulated. The suction unit always runs at max. speed.