User Manual

17
If you don't relief the pressure on the machine or put
furthermore too much pressure on the tool it reacts by
witching OFF the machine.
After automatic switch-OFF of the machine you can
continue working after switching OFF and ON the power
tool again.
Thermal: In case of permanent overload, a thermal sensor protects
the motor against destruction. In this case, the tool
switches off automatically and can only be restarted after a
certain cooling period (approx. 2 minutes). Actuate the
ON/OFF switch! The cooling period depends on the
heating of the motor winding and the ambient temperature.
Dust Exhaust
Dust which occurs during your work is hazardous to health. That is why it is
advisable to use a deduster and to wear a dust mask. For the EPF 1503 we
supply the industrial vacuum cleaners DSS 25, 35, 50 which can be
connected directly to the protective hood’s 35 mm hose connector.
The machine is designed according to the requirements mentioned in
TRGS 559 (technical regulations for hazardous materials) article 4.3.
Care and Maintenance
Before the beginning of the maintenance- or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the power tool needs a minimum of care and
maintenance. The following works have to be carried out or rather the
component parts have to be inspected:
 The power tool as well as the ventilation slots always have to be clean.
 During work, please pay attention that no foreign elements get into the
interior of the machine.
 In case of failure, a repair has to be carried out by an authorized
service workshop.
Environmental Protection
Raw Material Recycling Instead of Waste Disposal
In order to avoid damages during transportation, the tool has to be
delivered in solid packaging. Packaging as well as unit and accessories are
made of recyclable materials and can be disposed accordingly.