Installation & Assembly

ASSEMBLY INSTRUCTION

Eichholtz B.V. l Delfweg 52 l 2211 VN Noordwijkerhout l P.O. Box: 23, 2160 AA Lisse l The Netherlands l www.eichholtz.com

Turn off the electricity supply at the main circuit panel before installing.

Do not connect the electricity supply until your luminaire is fully

assembled and installed.

Screw part C to the lamp. Thread the wires through part C and part D

and ﬁx part D on part C.

If you are unable to place the bulbs with the shades on, you can remove

the shades by unscrewing the two cap nuts (J) at the top of each shade

(K). Move the shade upwards to remove it.

Fix the ceiling bracket (A) to the ceiling by using mounting plugs and

screws suitable to your ceiling type.

Place or hold the lamp in an elevated position in such a way that the

wires can freely reach the ceiling junction box.

Thread the wires through the components (suspension eye, retaining

nut, ceiling canopy) and connect the 3 power wires according to their

colours . Brown is the live wire, blue is the neutral wire, green/yellow is

the earth wire.

Screw the suspension eye (C) (with retaining nut attached) to the

ceiling bracket and ﬁx it securely by tightening the retaining nut (D).

Check whether the connection is sufﬁciently strong by manually loading

the chain.

Carefully lower the lamp until the chain is taut. Straighten the chain

links.

Screw part G to the lamp, slide part H over it and ﬁx it with the ﬁnial (I).

111655 CHANDELIER CLARIDGES

PAGE 1
11655 CHANDELIER CLARIDGES ASSEMBLY INSTRUCTION A Turn off the electricity supply at the main circuit panel before installing. Do not connect the electricity supply until your luminaire is fully assembled and installed. Screw part C to the lamp. Thread the wires through part C and part D and fix part D on part C. If you are unable to place the bulbs with the shades on, you can remove the shades by unscrewing the two cap nuts (J) at the top of each shade (K). Move the shade upwards to remove it.