Installation guide

APPC Status 104
APPC Status
When you issue the command ECMODULE STATUS APPC on an
SNA Gateway with an active APPC connection, status information on that
protocol is displayed.
The following command displays general information on APPC connections:
ECMODULE STATUS APPC
APPC Loadable Module Status
Card number: 1
Configured Used
Local LUs...................: 32 1
Remote LUs..................: 32 1
Mode entries................: 16 2
LU-LU sessions..............: 32 5
Conversations...............: 32 4
Transaction programs........: 32 4
Local LU Session Count
-------------------------
SEND 5
There are four levels of detail available with the APPC status commands. The
first level of detail shows status of a particular local LU.
ECMODULE STATUS APPC /N SEND
APPC Loadable Module Status
Node name...................: PU1
Local LU....................: SEND Fully qualified name: NETSNA.SEND
Session limit...............: 6 Queue allocate..............: 0
Session used................: 5 Remote LUs..................: 1
LU started..................: @14:56:42 Feb 26
Remote LU Session Count
---------------------------------
RECV 5
You may further obtain detailed status on the Remote LU with this command:
ECMODULE STATUS APPC /N SEND RECV
APPC Loadable Module Status
Node name...................: PU1 Local LU....................: SEND
Remote LU...................: RECV Fully qualified name: NETSNA.RECV
Uninterpreted name..........: RECV Modes.......................: 2
Local LU session limit......: 6 Remote LU session limit.....: 6
Local LU session used.......: 5 Remote LU session used......: 5
LU started..................: @14:56:42 Feb 26
Modes Session Count
--------------------------
SNASVCMG 1
MODENAME 4
Command
ECMODULE STATUS APPC [/Eiconcard n]
[/Name lluname [rluname [mode [session]]]]