Installation guide

APPC Statistics 109
APPC Statistics
When you issue the command ECMODULE STATS APPC on an
SNA Gateway with an active APPC connection, statistical information about
the protocol is displayed.
The following command presents global statistics on all APPC connections:
ECMODULE STATS APPC
APPC Loadable Module Statistics
Card number: 1
Local Remote
Successful sessions started..: 1 0
Unsuccessful sessions started: 0 0
Abnormal sessions end........: 0 0
Active sessions..............: 1 0
Pending sessions.............: 0 0
Terminated sessions..........: 0 0
Conversations started........: 1 0
Active conversations.........: 1 0
Note
Before you attempt to display any of the detailed statistics, run the
relevant ECMODULE STATUS SNA command in order to obtain a list of all
the active nodes, logical units and modes.
To display detailed statistics on a local LU, use the following command:
ECMODULE STATS APPC /N SEND
APPC Loadable Module Statistics
Card number: 1
Node name..............: PU1
Local LU name..........: SEND
Sent Received
BTUs...................: 236 119
Characters.............: 62420 1162
Further details can be obtained on any remote logical unit connected with the
specified node:
ECMODULE STATS APPC /N SEND RECV
APPC Loadable Module Statistics
Card number: 1
Node name..............: PU1
Local LU name..........: SEND
Remote LU name.........: RECV
Sent Received
BTUs...................: 236 119
Characters.............: 62420 1162
Command
ECMODULE STATS APPC [/Eiconcard n]
[/Name lluname [rluname [mode ]]]