Installation guide

Overview of the Command Line Utilities 65
Overview of the Command Line Utilities
The command line utilities described in this chapter are briefly summarized
below. Commands are described in separate sections which are presented in
alphabetical order in this chapter.
ECADMIN
This command starts the Eicon Configuration Program. You can also start the
Eicon Configuration Program from the Start menu or from the Control Panel.
ECCARD
The ECCARD START command loads the ELMs (Eicon Loadable Modules)
or ERMs (Eicon Relocatable Modules) and starts the Eiconcard. ECCARD can
also be used to stop the Eiconcard, view its status, and dump the contents of
its memory to a file for analysis.
ECDIALER
This command is used to control the Eiconcard dialer and physical layer
connections using internal or external modems. ECDIALER instructs the
Eiconcard to make calls, answer calls, and to display status information.
ECHP
This command is used to start, stop and view the status of host print sessions.
ECMODULE
If you need to monitor the data communications traffic going through the
gateway PC, ECMODULE lets you analyze different levels of protocols.
ECMODULE is not required to run the gateway PC; it is a diagnostic tool.
The ECMODULE command is explained in detail in “ECMODULE
Command” on page 98.
ECNCBLOG
ECNCBLOG is a diagnostic utility used to trace NCBs (Network Control
Blocks) sent to the Eiconcard.
ECSERVER
ECSERVER (Eiconcard LAN Server) allows the gateway PC to provide
communications services to workstations on the local area network (LAN).