Installation guide
WAN-Miniport driver 27
3. In the ‘Change Port’ dialog box, select the adapter that is to be assigned to the port.
Click ‘OK’.
4. You can also leave a port unassigned so that the port number is reserved for
subsequent configurations (see the illustration below).
Click ‘OK’. The configured port is displayed in the ‘Eicon WAN-Miniport Driver Setup’.
Note: If new ports are added or deleted, the changes will become effective only when
the system is restarted.
5. If you do not plan to use the Eicon WAN Miniport with advanced configuration, click
‘OK’ to terminate the WAN-Miniport driver configuration.
Advanced parameters for the WAN-Miniport driver
The ‘Advanced Parameters’ are only required in the following circumstances:
• To configure MSN/EAZs or subaddresses
• To use the shorthold mode
• For additional access security
• If there are problems with the driver
Select the option ‘Advanced Parameters’ in the ‘Eicon WAN-Miniport Driver Setup’ dialog
box. You may now configure MSNs or subaddresses in the ‘Add Port’ or ‘Change Port’
dialog boxes (see Configuring phone numbers/extensions and subaddresses
on page 29).