Installation guide
Remote Access Service (RAS) 40
Enable Multilink (Windows NT Server only)
The ‘Enable Multilink’ option activates channel bundling according to the Multilink PPP
standard. This means that two or more (max. 6) B-channels or channelized T1 channels
can be bundled for a single higher-speed connection.
Note: Additional information on setting up the network protocols can be found in the RAS
online help or the Windows NT RAS documentation.
Completing the RAS interface configuration
To close the network configuration: Click ‘OK’ in the ‘Network Configuration’ dialog box
and then click ‘Continue’ in the ‘Remote Access Setup’ dialog box. Close the ‘Adapter’
dialog box. This completes the RAS configuration.
Follow the directions on the screen and read the corresponding section in this manual:
• If the Security Dynamics Authentication in the ‘Advanced Parameters’ of the
WAN-Miniport driver has been configured, the Eicon Authentication Service must be
installed. Click ‘Ye s ’ when the program prompts for this service to be installed. See also
Eicon Authentication Service
on page 81.
• If you wish to install the Eicon Port driver, click ‘Ye s ’ to confirm. See Eicon Port driver
on page 41.
• If you wish to install the Eicon driver for CAPI 2.0, click ‘Ye s ’ to confirm. See CAPI 2.0
on page 56.
• When the installation and configuration are finished, restart the computer.