Installation guide
Changing Your Installation 83
6. Add the newly installed adapter and set up the ports (see also Configuring the Eicon
Port driver on page 42).
7. Click ‘OK’.
Changing the configuration
Reconfiguring the Diva Server adapter, the WAN-Miniport driver, the Port
driver, or the
CAPI 2.0
Reconfigure the settings for the adapter, the WAN-Miniport driver, the Port driver, or CAPI
2.0 as follows:
1. Click ‘Start > Settings > Control Panel’. Double-click ‘Network’.
2. Click the required tab:
• Select the ‘Adapter’ tab, if you wish to reconfigure the adapter or the WAN-Miniport
driver.
• Select the ‘Services’ tab, if you wish to reconfigure the Port driver.
• Select the ‘Software’ tab, if you wish to reconfigure CAPI 2.0.
3. Select the component that you wish to reconfigure and click ‘Properties’.
4. The required configuration dialog box in which the settings can be changed will appear.
5. After closing the configuration dialog box, the new configuration data is written into
the system.
The changes will be effective only after restarting the computer. When the ‘Network’ dialog
box is closed, a restart prompt will appear.
Reconfiguring the Diva Server TSP
Reconfigure the Diva Server TSP as follows:
1. Click ‘Start > Settings > Control Panel’. Double-click ‘Telephony’.
2. Click the ‘Telephony Drivers’ tab.
3. Select the ‘Diva Server Telephony Service Provider’ and click ‘Configure’.
4. The required configuration dialog box in which the settings can be changed appears.
5. After closing the configuration dialog box, the new settings are written into the system.