Installation guide
Installation in Unattended Mode 97
RBSNoAnswerSupervision:
For ‘GroundStart’ and ‘LoopStart’ trunk modes only. ‘Answer Supervision’ detects when
the remote side answers a call and thus ensures accurate billing of a call. Possible settings
are:
• 0 (off): Answer supervision is disabled and the standard connection detection based
on tones is used.
• 1 (on): Answer supervision is enabled and the line detects when the remote side
answers a call.
Specific parameters for Q-Sig
QSIGPBXType
QSIGPBXType defines the type of your PBX. If your PBX is not listed, use the value for
‘Generic PBX’. Possible settings are:
• 0: Generic PBX
• 1: Siemens HICOM 300
• 2: Siemens HICOM 150
• 3: Alcatel 4400, 4410, 4200
• 4: Ericsson MD110
• 5: Ericsson BP250
• 6: Lucent Definity
• 7: matra6500
• 8: Nortel
QSIGStandard:
Set the ‘QSIGStandard’ that is required for the selected Q-Sig PBX type. Possible settings
are:
• 0: Automatic
• 1: ISO
• 2: ECMA
• 3: ECMAV1
• 4: ECMAV2
For the proper setting refer to the documentation that came with your PBX.