Instructions / Assembly

ManualsBrandsEightDoors ManualsSlab Doors70288014803035SH

EIGHT DOORS CORP.

e-mail: doors@eightdoors.com

Website: EightDoors.com

USE AND CARE INSTRUCTIONS

INTERNAL PRIMED DOOR

INTRODUCTION

Timber is a natural grown product and as such is subject to changes due to variations in moisture and temperature

resulting in minor swelling and shrinking. This is not a defect but a natural characteristic of timber. Warp at the face of

the door will be considered a defect if it exceeds 1/4 inch when measured as deviation from a straight edge on the

suspected concave surface of the door in its installed position.

STORAGE & HANDLING

This door must be stored in a dry and flat location. Do not expose the door to temperatures above 90 degrees

Fahrenheit and/or to direct sunlight. Do not expose the door to humidity level higher than 65%RH and lower than

30%RH.

Do not remove packaging until the door is to be installed.

radiators or direct

air moisture content

sunlight

is down to normal

domestic levels

PRECAUTIONS

This door is not recommended for installation in any new build or freshly plastered location. All plaster, texture or

cement must be completely dry to avoid excessive moisture penetration.

Page 1 of 5

Summary of content (5 pages)

PAGE 1
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com USE AND CARE INSTRUCTIONS INTERNAL PRIMED DOOR INTRODUCTION Timber is a natural grown product and as such is subject to changes due to variations in moisture and temperature resulting in minor swelling and shrinking. This is not a defect but a natural characteristic of timber.
PAGE 2
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com It is essential that door should be sealed with a suitable base sealer on both faces and four edges and any cutouts immediately. It is of utmost importance that both ends are completely sealed, as this is where moisture can most easily penetrate the timber. Moisture may cause swelling, splitting or warping.
PAGE 3
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com Choose any paint indicated for WOOD APLICATION that suits your taste and apply it according to the paint manufacturer instructions; our door are primed with a water-based primer. Be sure that previous layer of paint coat is completely dry before applying the next one. Cover all surfaces evenly! BE SURE TO SEAL TOP AND BOTTOM of doors, as well as all sides. Apply a minimum of two top coats, sanding between coats.
PAGE 4
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com INSTRUCCIONES DE USO Y CUIDADOS INTRODUCCIÓN Madera es un producto cultivado naturalmente y está sujeta a cambios debido a las variaciones de humedad y temperatura del ambiente, resultando en un mínimo hinchazón y encogimiento. Esto no es un defecto, sino una característica natural de la madera.
PAGE 5
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com IMPRIMADO DE FÁBRICA & LISTO PARA PINTAR Lijar la puerta entera ligeramente usando una lija grano #220 o superior (el lijado pesado con una lija gruesa puede dañar las chapas). Quite completamente todo el polvo con un paño adhesivo limpio antes de aplicar el acabado. NO USE aire comprimido para quitar el polvo de la puerta ya que la humedad en el aire causará manchas de agua.