Use and Care Guide

ManualsBrandseightdoors ManualsDoors & WindowsZ-Frame Barn Knotty Pine Wood Interior Slab Door 84 x 42 x 1-3/8-in

Page 1 of 6

EIGHT DOORS CORP.

e-mail: doors@eightdoors.com

Website: EightDoors.com

USE AND CARE INSTRUCTIONS

INTERNAL UNFINISHED DOOR

INTRODUCTION

Timber is a natural grown product and as such is subject to changes due to variations in moisture and temperature

resulting in minor swelling and shrinking. This is not a defect but a natural characteristic of timber. Warp at the face of

the door will be considered a defect if it exceeds 1/4 inch when measured as deviation from a straight edge on the

suspected concave surface of the door in its installed position.

STORAGE & HANDLING

This door must be stored in a dry and flat location. Do not expose the door to temperatures above 90 degrees

Fahrenheit and/or to direct sunlight. Do not expose the door to humidity level higher than 65%RH and lower than

30%RH.

Do not remove packaging until the door is to be installed.

PRECAUTIONS

This door is not recommended for installation in any new build or freshly plastered location. All plaster, texture or

cement must be completely dry to avoid excessive moisture penetration.

radiators or direct

sunlight

air moisture content

is down to normal

domestic levels

Summary of content (6 pages)

PAGE 1
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com USE AND CARE INSTRUCTIONS INTERNAL UNFINISHED DOOR INTRODUCTION Timber is a natural grown product and as such is subject to changes due to variations in moisture and temperature resulting in minor swelling and shrinking. This is not a defect but a natural characteristic of timber.
PAGE 2
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com It is essential that door should be sealed with a washcoat or sealer (it depends on the finish being applied) on both faces and four edges and any cutouts immediately. It is of utmost importance that both ends are completely sealed, as this is where moisture can most easily penetrate the timber. Moisture may cause swelling, splitting or warping.
PAGE 3
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com Choose a good quality oil-based primer and a solvent-based enamel that suits your taste and apply it according to the manufacturer instructions. Apply a minimun of two top coats of solvent-based enamel. Be sure that previous layer of coat is completely dry before applying the next one. Cover all surfaces evenly! BE SURE TO SEAL TOP AND BOTTOM of doors, as well as all sides.
PAGE 4
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com INSTRUCCIONES DE USO Y CUIDADOS INTRODUCCIÓN Madera es un producto cultivado naturalmente y está sujeta a cambios debido a las variaciones de humedad y temperatura del ambiente, resultando en un mínimo hinchazón y encogimiento. Esto no es un defecto, sino una característica natural de la madera.
PAGE 5
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com ACABADO Primero se debe colgar la puerta en su marco y perforar todos los agujero para herraje. Despues se debe retirar la puerta del marco, sacar las herrajes y aplicar el acabado con la puerta acostada. Lijar la puerta entera ligeramente usando una lija grano #220 o superior (el lijado pesado con una lija gruesa puede dañar las chapas). Quite completamente todo el polvo con un paño adhesivo limpio antes de aplicar el acabado.
PAGE 6
EIGHT DOORS CORP. e-mail: doors@eightdoors.com Website: EightDoors.com • • No se aceptará reclamación si la puerta no ha sido aparada/cortada, acabada, sellada e/o instalada correctamente de acuerdo con las instruciones anteriores de USO Y CUIDADOS. Todas las puertas deben estar bien sellada en las seis superficies.