Owner`s manual

46
Expand

Note:
Factory default: "Ready: 5 min".
Filter counter
This function is used to set a frequency for lter
cleaning.
When the projector reached a specied time
between cleanings, a Filter warning icon
appears on the screen, notifying the cleaning
is necessary. After cleaning the lter, be sure
to select Filter counter reset and set the timer.
The Filter warning icon will not turn off until the
lter counter is reset.
Filter counter..........The time that lter used.
Timer.......................Frequency for lter
cleaning.
Filter counter reset.. Reset the filter counter
(Page 55)
Power management
Filter counter
PC adjust
Display
Color adjust
Setting
Expand
Info.
Adjust Select Back
Power management
Ready
Shut down
Off
Timer 5 Min
Ready countdown 0 Min

PC adjust
Display
Color adjust
Setting
Expand
Info.
Move Next Back
Filter counter
Filter counter 0 H
Timer 400 H
Filter counter reset
Power management
No signal
01 : 20
Time left before Lamp is off.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management
function turns off the projection lamp when the projector is not operated for a certain period. Select
one of the following options:
Ready .........
...
...... When the lamp has been fully cooled down, the POWER indicator changes
to green blinking.In this condition, the projection lamp will be turned on if the
input signal is reconnected or any button on the top control or remote control
is pressed.
Shut down ........ ....When the lamp has been fully cooled down, the power will be turned off.
Off ......................... Power management function is off.
Timer .................... If the input signal is interrupted and no button is pressed for more than 30
seconds, the timer display with No signal appears. It starts the countdown
until the lamp is turned off. Press

button to set the Timer(1~30min.)
Ready countdown..Set the time that ready status transfers to standby status automatically.(0-
30min.0 Min: not transfer automatically)
In ready status, press POWER button to switch to standby status, and press
any other button to turn on the projector.