Owner`s manual

62
Indicator
State of projector
POWER
(Green/Red/
Orange)
WARNING
(Red)
Powered off (not in standby mode)
The projector is off. (AC power cord not connected).
Power on
The projector is operating normally.
In standby mode
- In standby mode. Press POWER to power on the projector.
- When the projector is cool enough, the temperature is restored
to the normal value, you can turn on the projector. And the
POWER indicator stops ashing.
High temperture alarm
Internal temperature too high and can’t be turned on. When the
projector is cool enough, the temperature is restored to the normal
value and the POWER indicator lights red, you can turn on the
projector .
In power management mode.
Cooling
Ready for standby mode or the lamp is being cooled. Before you
turn on the projector, you should wait till the lamp is cool enough
and the POWER indicator stom ashing.
Error
Can’t be turned on because error is detected. You should unplug
the power cord. Then insert it again and power on the projector.
If the projector is powered off again, you should cut off the power
and contact the local distributor or repair center. In this case, stop
the projector. Otherwise, electric shock or re may occur.
Lamp life alarm
The lamp has been used over time.
Replace the lamp immediately.*
Indicator and projector state
Check the indicator to know about the state of projector.
* When the lamp reaches the end of its life, the WARNING indicator lights red. In this case,
replace the lamp with a new one promptly.
....Green
....Red
....Orange
....Off
....Green ashes
....Red ashes
....Orange ashes
?
?
Appendix