Owner`s manual

70
Appendix
– Check PC adjustment or Screen and adjust them.
See pages 35-36, 39-40.
– PIN code lock is being set. Enter a PIN code ("1234" or numbers
you have set). See pages 22, 58-59.
– Make sure your computer is connected to the projector with USB
cable. See page 17.
– Check the batteries.
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 57.
– Unlock the Key lock function for the remote control function. See
page 58.
– Check RESET/ON/ALL-OFF switch on the remote control is set to
ON. See page 12.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 74.
– Check the connection between the projector and your computer.
– Check the mouse setting on you computer.
– Make sure the mouse driver is installed on your computer,
otherwise, the remote control can not be used as a wireless mouse.
– Make sure the signal is from the computer, otherwise, the remote
control can not be used as a wireless mouse.
– Turn on the projector before turning on the computer.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at Key lock
under Security of Setting section. See page 58.
– Contact the dealer where you purchased the projector or the service
center.
The image is distorted or runs off.
PIN code dialog box appears at
start-up.
Page Up/Down function does not
work.
The Remote Control does not work.
Indicator blinks or lights.
Wireless Mouse function does not
work.
The exclamation mark appears on
the screen.
Top control does not work.
Unable to unlock the Logo PIN code
lock, Security key lock or Security
PIN code lock.