Owner`s manual
Basic Operation
Turnin
g
off the Pro
j
ector - Procedure
1.
Press
the
power
button
on
the
projector
or
remote
control.
The
power
off
confirmation
message
appears
.
2.
Press
the
power
button
again
and
the
projector
will
enter
cool-down
mode.
The
lamp
shuts
off,
the
lamp
indicator
flashes
red,
and
the
fans
continue
to
run
for
approximately
two
minutes.
During
the
cool
down
sequence
the
projector
will
not
respond
to
any
control
panel
or
remote
control
buttons.
Do not set the power switch to off or unplu
g
the
projector during the cool-down sequence. Not allowing
the lamp to cool properly will greatly reduce the life
of the lamp.
C
A
U
T
I
O
N
3.
After
the
cool-down
sequence is completed the
fans
will
shut
of
f
and the
lamp
indicator
will
stop
flashing.
The
projector
is
now
in
standby mode
and
can
be
turned
back
on
with
the
remote
control
or
control panel.
If
the
projector
will
not
be
used
for
an
extended
period,
set the
power
switch
to
off
and
disconnect
the
power
cord.
51
Downloaded From projector-manual.com EIKI Manuals