User manual

11
 CAUTION
Read all safety regulations and instructions. Any
errors made in following the safety regulations and
instructions may result in an electric shock, fire and/or
serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. LCD
2. „On / Standby“ button
3. „Temperature setting“ button
4. „Heat output setting“ button
5. „Timer“ button
6. „▼lower“ button
7. „▲higher“ button
8. Foot
9. Glass cover
10. Remote control
3. Items supplied (Fig. 2)
n Open the packaging and take out the equipment
with care.
n Remove the packaging material and any
packaging and/or transportation braces (if
available).
n Check to see if all items are supplied.
n Inspect the equipment and accessories for
transport damage.
n If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
n 1x Glass convector (11)
n 1 x Remote control (10)
n 2x Foot (8)
n 2x Upper wall holder (12)
n 1x Lower wall holder (13)
n 2x Plastic wall plug 8 mm (14)
n 3x Screw M4x10 for the wall holders (15)
n 8x Screw M4x10 for the feet (16)
n 2x Screw for wall mounting (17)
n Original operating instructions
4. Intended use
The equipment is designed for use as an additional
heater in dry, enclosed areas. Operate the equipment
only when it is completely assembled and standing
on the floor or hanging on the wall. It is prohibited to
operate the equipment on an unstable surface (e.g.
on a bed). Never mount the equipment on a wall
which is not capable of bearing the load or which is
combustible, on angled surfaces, or on the ceiling.
The equipment may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications.
Our warranty will be voided if the equipment is used in
commercial, trade or industrial businesses or for
equivalent purposes.
5. Technical data
Rated voltage: 230 V ~ 50 Hz
Heat output: 2000 W
Thermostat control: 15°C -50°C
Protection class: I
Equipment dimensions without feet
approx.: 86 x 10 x 46.5 cm
Equipment dimensions with feet
approx.: 86 x 23 x 52.5 cm
6. Before starting the equipment
6.1 Assembly
The equipment can be used indoors in a free
standing position or mounted on a wall. The minimum
clearances must be observed. The equipment is
allowed to be used only when it is completely
assembled and in a vertical position.
a) Free-standing installation (Fig. 3)
Ensure that a minimum distance of 30 cm to the
sides, 60 cm to the top and 100 cm to the front of the
equipment are maintained.
Observe point 1 - Safety information.
Important! To prevent damage when attaching the feet
GB
Anleitung_GCH_2000_SPK7__ 08.03.13 11:37 Seite 11