User manual

14
GB
Fault Possible cause Remedy
The equipment does not heat The power plug is not connected
The main switch is not turned on
The equipment is in standby mode
or the antifreeze function is active
The thermostat is set too low
The overheating guard has
triggered
Connect the power plug
Turn on the main switch
Set the heat output (1000 W /
2000 W)
Increase the temperature (°C)
Note section 7.5
11. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults. In the
event of any malfunctions or faults, please check the following before you contact your customer services.
Anleitung_GCH_2000_SPK7__ 08.03.13 11:37 Seite 14