Full Product Manual

EN
- 21 -
11. Troubleshooting
Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If the problem still persists after working through the list, please
contact your nearest service workshop.
Cause Fault Remedy
Chainsaw does not
work at all
- Quick stop brake has been
triggered
- No power supply
- Pull the hand protection back to the
normal position.
- Check the rechargeable battery
Chainsaw operates
intermittently
- Loose connection (internal)
- ON/OFF switch defective
- Consult a specialist workshop.
- Consult a specialist workshop.
Saw chain is dry - No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet is blocked
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
Chain brake does
not work
- Problem with the switch mechanism
in the front hand guard
- Consult a specialist workshop.
Chain/guide bar
is hot
- No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet is blocked
- Chain is blunt
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Re-sharpen or replace the chain
Chainsaw judders,
vibrates or does not
saw properly
- Chain is undertensioned
- Chain is blunt
- Chain is worn
- Saw teeth point in the wrong
direction
- Adjust the chain tension
- Re-sharpen or replace the chain
- Replace the chain
- Refi t the chain with the teeth facing
in the correct direction
Anl_GE_LC_18_Li_SPK7_USA.indb 21Anl_GE_LC_18_Li_SPK7_USA.indb 21 29.05.2019 13:54:5929.05.2019 13:54:59