Operation Manual

 Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
 CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout and items supplied
(Fig. 1)
2.1 Layout
1. Dust guard
2. Locking sleeve
3. Rotary switch for rotation stop facility
4. ON/OFF switch
5. Rotary switch for hammer stop facility
6. Additional handle
7. Depth stop
8. Handle
2.2 Items supplied
 Open the packaging and take out the equipment
with care.
 Remove the packaging material and any
packaging and/or transportation braces (if
available).
 Check to see if all items are supplied.
 Inspect the equipment and accessories for
transport damage.
 If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
 Hammer drill
 Additional handle
 Depth stop
 Dust collection device
 Original operating instructions
 Safety instructions
3. Proper use
The tool is designed for drilling with hammer action in
concrete, rock and brick, as well as for chiseling
work, always using the respective correct drill or
chisel bit.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage: 220-240 V ~ 50 Hz
Power input: 900 W
Idling speed: 850 rpm
Blow rate: 4100 rpm
Drilling capacity in concrete/stone (max.): 26 mm
Protection class: II / 쓑
Weight: 4.1 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level 91.1 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 102.1 dB(A)
K
WA
uncertainty 3 dB
GB
11
Anleitung_BT_RH_900_1_SPK1:_ 29.03.2012 9:02 Uhr Seite 11