User Manual

GB
- 29 -
11. Troubleshooting
Fault Possible causes Remedies
The motor fails to
start
a) Motor terminals disconnected
b) The mower is standing in high
grass
c) The mower housing is clogged
d) Safety switch is not inserted
e) Battery is not correctly inserted
a) Have repaired by the Customer
Service Center
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
c) Clean the housing so that the blade
moves freely
d) Insert safety switch (see 6.)
e) Remove the battery and reinsert
(see 5.)
The motor perfor-
mance drops
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) Correct the cutting height
b) Clean the housing
c) Replace the mower spindle
d) Check the battery performance
and charge the battery if necessary
(see 5.)
Cutting is irregular a) The blade is worn
b) Wrong cutting height
c) The distance between the counter
blade and mower spindle is too
large
a) Resharpen the blades or replace
the mower spindle
b) Correct the cutting height
c) Adjust the distance (see 7.3)
The mower spindle
does not turn
a) The counter blade and mower
spindle are touching each other
a) Adjust the distance (see 7.3)
The push bar does
not stay held in the
push bar holder
a) The fastening screws are not scre-
wed into the V-shaped notch in the
push bar bottom section
a) Remove the fastening screws and
repeat the assembly procedure
(section 5.1/Fig. 5 - 5d)
Important! For protection, the motor is equipped with a thermal switch which cuts out when
the motor is overloaded and switches on again automatically after a short cooling period.
Anl_GE_HM_18_38_Li_SPK9.indb 29 24.09.2020 15:24:51