Use and Care Manual

EN
- 12 -
4. Technical data
Motor power supply: ........................... 18 V
Idling speed: ............................. 2500 min
-1
(rpm)
Polishing disk: ........................ 10 in. (Ø 254 mm)
Weight: .........................................4.6 lbs (2.1 kg)
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment‘s construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
5. Before starting the equipment
The equipment is supplied without batteries
and without a charger.
5.1 Fitting the battery (Fig. 4-5)
Push the battery into the battery mount provided.
When the battery is positioned as in Fig. 5, make
sure that the pushlock button latches in place! To
take out the battery, press the pushlock button
and remove the battery (Fig. 6).
6. Operation
Warning!
Always remove the battery pack before making
adjustments to the equipment.
6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 3)
Press the battery capacity indicator switch (7).
The battery capacity indicator (6) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
6.3 Mounting the polishing bonnet on the
polishing disk (Fig. 7)
1. Turn the car polishing machine upside down
so that the polishing disk is facing up.
2. Pull the textile polishing bonnet over the
polishing disk. Make sure that the textile
polishing bonnet is free of any foreign bodies.
6.4 Applying wax/polishing paste to the
textile polishing bonnet (Fig. 8)
Note: Use only high-quality waxing and polishing
products and follow the processing instructions
issued by the manufacturer on the packaging.
Distribute the polishing agent evenly as far as
the edge of the textile polishing bonnet so that a
uniform, thin coating is produced overall.
Note: Applying too much polishing agent will
only make it more diffi cult to remove the layer of
polishing agent later from the paintwork and will
not improve the results.
Anl_CE_CB_18_254_Li_SPK7_USA.indb 12Anl_CE_CB_18_254_Li_SPK7_USA.indb 12 17.12.2018 16:24:1617.12.2018 16:24:16