Komponenten / Ersatzteile Position Artikel-Nr.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 1 Operating Instructions for Petrol Grass Trimmer 34.016.87 Art.-No.: 941479 I.-No.
Anleitung SGT 24 GB 2 10.11.
Anleitung SGT 24 GB 10.11.
Anleitung SGT 24 GB 5d 10.11.
Anleitung SGT 24 GB 9a 10.11.
Anleitung SGT 24 GB 12a A 10.11.
Anleitung SGT 24 GB 10.11.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 8 GB WHAT NOT TO DO 1. DO NOT USE ANY OTHER FUEL than that recommended in your manual. Always follow instructions in the Fuel and Lubrication section of this manual. Never use gasoline unless it is properly mixed with 2 stroke oil. Permanent damage to engine will result, voiding manufacturer’s warranty. 2. DO NOT SMOKE while refueling or operating equipment. 3. DO NOT OPERATE UNIT WITHOUT A MUFFLER and properly installed muffler shield. 4.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 9 GB Assembly instructions RECOMMENDED FUELS • Handle Assembly NOTE: The Handle is attached to the shaft but has beened turned under for ease of packing. 1. Loosen adjustment knob and rotate handle to top of shaft. Position handle 160mm - 220mm from throttle (Fig. 1b). 2. Tighten adjustment knob securely. Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 10 GB • WARM ENGINE START • STRINGHEAD LINE RELEASE 1. Place trimmer on firm flat surface. 2. Move ignition switch to the “RUN (I)” position (Fig. 6). 3. Grip handle firmly, squeeze throttle trigger to FULL position. 4. Pull starter rope briskly until engine starts, but no more than 6 times. 5. If engine does not start, please operate “STARTING A COLD ENGINE” again.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 11 GB TRIMMING AROUND TREES Trim around tree trunks with a slow approach so string does not contact bark. Walk around the tree trimming from left to right. Approach grass or weeds with the tip of the line and tilt stringhead slightly forward. WARNING: Use extreme caution when SCALPING. Keep a distance of 100 feet (30 meters) between operator, other people and animals during these operations.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 12 GB • CARBURETOR ADJUSTMENT The carburetor was pre-set at the factory for optimum performance. If further adjustments are necessary, please take your unit to the nearest Authorized Service Center. • SPARK PLUG 1. Spark plug gap = .025" (.635mm) (Fig. 13). 2. Torque to 105 to 130 inch pounds (12 to 15 N•m). Connect spark plug boot. • DEBRIS SHIELD KNIFE SHARPENING 1. Remove cutter knife (E) from debris shield (F) (Fig. 14). 2. Place knife in a bench vise.
Anleitung SGT 24 GB ISC GmbH Eschenstraße 6 D-94405 Landau/Isar D F E P S 10.11.
Anleitung SGT 24 GB 10.11.2004 14:31 Uhr Seite 14 GARANTIEURKUNDE Auf das in der Anleitung bezeichnete Gerät geben wir 2 Jahre Garantie, für den Fall, dass unser Produkt mangelhaft sein sollte. Die 2-Jahres-Frist beginnt mit dem Gefahrenübergang oder der Übernahme des Gerätes durch den Kunden. Voraussetzung für die Geltendmachung der Garantie ist eine ordnungsgemäße Wartung entsprechend der Bedienungsanleitung sowie die bestimmungsgemäße Benutzung unseres Gerätes.