User Manual

Note: If the installation program does not start on its own, use Windows Explorer to locate and
launch setup.exe on the CD-ROM.
4. Follow the instructions to install InterWrite.
5. Remove the CD-ROM.
6. Restart the PC. The InterWrite icon should appear in the Taskbar.
Next: Installation is complete.
- END –
Basic operation
Note:
One MenuPads can communicate with one receiver.
Each MenuPad must be within 15 feet (4.5m) of its intended receiver. Reception
depends on local conditions, and performance may vary in your facility.
MenuPad receivers should be at least 100 feet (30m) apart.
To do this... Do this...
Turn MenuPad is only on when touching the surface and for sort time after that.
Tip: "Quick start for InterWrite Software" and the InterWrite Software help file contain instructions
for using that product to control the PC, annotate screens, save screens and distribute meeting
notes.
- END –
About MenuPad help
InterWrite MenuPad help, Rev. x0 4-26-01
© 2001 GTCO CalComp, Inc. All rights reserved. No part of this publication may be reproduced,
stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise, without the prior written permission of GTCO CalComp,
Inc.
InterWrite, MenuPad, MeetingBoard and DrawingBoard Interactive are trademarks of GTCO
CalComp, Inc. GTCO is a registered trademark of GTCO CalComp, Inc.
- END –
Care and cleaning
Replacing pen batteries
1. Slide open the cover.
2. Insert the batteries with "+" matching the + on the tablet.
3. Replace the cover
General care