User Manual

Welcome Page 22 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
b. Hang the tablet by interlocking the mounting brackets as shown below.
Next: Assemble the electronic pen(s).
2b. Mount the tablet on the optional floor stand
CAUTION: To avoid damage to the controller, do not rest the SchoolBoard tablet on the controller housing (located on the rear
of the tablet near one corner). Do not scratch or damage the tablet's writing surface.
WARNING: Never nail or drill the SchoolBoard tablet. Doing so will damage the unit and void your warranty.
IMPORTANT: To avoid damage to the tablet or injury, two people should carry out this mounting procedure.
a. Attach each mounting bracket to the back of the tablet using four small screws and nuts as shown below.
b. Using four screws, attach one foot to the bottom end of one leg (the end without crossbar holes). Attach two casters to each
foot. Insert three end caps (two on the foot and one on the leg). Repeat for the other foot and leg.
A Tablet
B Wall
A Screw
B Nut
C Mounting bracket
D Tablet
A Foot
B Leg
C End caps (6)
D Lock washer (4)
E Caster (4)
F Screw, 1/4
-
20 x 2" flat head