User Manual

Welcome Page 26 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
Next: Calibrate SchoolBoard.
3. Calibrate SchoolBoard
Tip: To assure the electronic ink is properly aligned, always recalibrate after moving the table or projector.
a. Plug the SchoolBoard power supply into an electrical outlet.
You should hear at least four beeps from the SchoolBoard.
b. Turn on the computer.
c. Turn on the projector.
d. Aim the projector at the SchoolBoard's writing area, and size the projected image to fit within the writing area.
Note: Make certain the image from the PC is properly projected before continuing.
e. Start > GTCO CalComp InterWrite > Interactive Mode.
f. In the Control Bar, click the InterWrite icon , then Tools > Calibrate.
Tip: If an error occurs during calibration, simply cancel and start over.
g. The calibration screen will be projected on the tablet. As prompted by the software, click each of the calibration points using the
SchoolBoard electronic pen.
h. When calibration is complete, the InterWrite Control Bar will appear. This menu, which remains in front of all applications, enables
A Win 98/ME/2000/XP computer
B USB adapter
C SchoolPad 100
n For serial connection: With computer OFF,
connect tablet to computer's serial port using
the serial adapter (as shown at right). Turn
computer ON. You will be prompted to install
drivers.
A Win 95/98/ME/2000/XP computer
B Serial adapter
C SchoolPad 100