User Manual

Welcome Page 5 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
MeetingPad 300: (optional) install the pen cord
The pen cord enables the MeetingPad 300 pen to operate without batteries. The cord also keeps the pen tethered to the tablet, making it
less likely to be lost. To install the pen cord:
1. Remove the pen cap, cover and batteries.
2. Feed black battery replacement end through cover.
3. Feed yellow and black wires through notches in inner housing.
4. Push black battery replacement end of cord into area where batteries were (see below), making sure the yellow wire is toward the pen
tip for correct polarity. Hold silver battery contact located on underside of inner housing with thumb while pushing black battery
replacement into place.
5. Push strain relief into hole at end of inner housing. Do not push all the way through.
6. Replace pen cover and cap.
7. Plug the cord into the POINTER jack on the tablet.
MeetingPad 300: install the Bluetooth hub
Install the Bluetooth hub according to instructions provided on the Bluetooth CD-ROM. The Bluetooth hub enables MeetingPad 300s to
communicate with the PC.
Note: Up to 7 MeetingPad 300s can communicate with one Bluetooth hub.
A Batteries
B Cover
C Cap
B Cover
C Cap
D Black battery replacement
E Black wire
F Yellow wire
G Strain relief
H Notches
I Inner housing
D Black battery replacement
E Black wire
F Yellow wire
I Inner housing
J Pen tip
K Silver battery contact