User Manual

Welcome Page 6 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
Note: Each MeetingPad 300 must be within 25 feet (7m) of its intended Bluetooth hub. Reception depends on local
conditions, and performance may vary in your facility.
1. Attach the pen tray to the tablet
CAUTION: To avoid damage to the controller, do not rest the MeetingBoard tablet on the controller housing (located on the
rear of the tablet near one corner). Do not scratch or damage the tablet's writing surface.
Attach the tray brackets to the bottom rear of the tablet using Phillips screws as shown below.
Next: Mount the tablet on a wall.
or
Mount the tablet on the floor stand.
2a. Mount the tablet on a wall
CAUTION: To avoid damage to the controller, do not rest the MeetingBoard tablet on the controller housing (located on the
rear of the tablet near one corner). Do not scratch or damage the tablet's writing surface.
WARNING: Never nail or drill the MeetingBoard tablet. Doing so will damage the unit and void your warranty.
IMPORTANT: To avoid damage to the tablet or injury, two people should carry out this mounting procedure.
a. Remove the protective backing from the adhesive on the two tablet levelers. Press the tablet levelers into place in the approximate
locations (C) shown below.
A Tablet
B Pen tray
C Phillips screw (4)
D Assembled view