User Manual

Welcome Page 9 of 54
file://C:\TEMP\~hhA856.htm 8/12/02
Next: Assemble the electronic pens.
3. Assemble the MeetingBoard pen(s)
A Thumbscrew (2)
B Mounting bracket
C T
-
slot (typical)
a. Locate the marker holders, electronics modules,
batteries, pen caps and markers supplied.
The pens are electronically coded to match the plastic
colors: black, blue, red and green.
b. Remove the marker's cap and replace it with a
MeetingBoard pen cap.
c. Insert a marker into the pen housing with the matching
color (e.g., red marker goes in red housing)
A Marker holder
B Electronics module
C Marker
D Pen cap
Note: Keep the markers capped as much as possible to prevent them from drying out. The caps enable the electronic pens
to be used in Interactive Mode without leaving ink on the tablet.
d. Remove the battery cover from a pen electronics
module. Insert a battery into the module (assure polarity
is correct!). Replace the battery cover.
e. Snap the pen electronics module into a marker housing
(any module can be used with any marker housing).