User's Manual

Table Of Contents

copy running-config startup-config

reboot

3.4. LibraPlus Field Installation

This section discusses how to install, conﬁgure and test a LibraPlus in the ﬁeld.

Before you can install LibraPlus equipment in the ﬁeld:

• All units should be conﬁgured as described in the Conﬁguration section

• Site preparation work must be complete

• Ensure all necessary tools and equipment are available

3.4.1. Site Preparation

Site preparation involves checking actual customer site conditions and ensuring that the site is ready

for LibraPlus installation. Each site is unique, however the following guidelines are provided.

1. Obtain a customer site plan or make a site plan. This document should describe where to place the

LibraPlus unit, what kind of equipment to use, and the required conﬁguration settings of the unit.

2. Cables should always be connected without exceeding their recommended bend radius.

3. Ensure that there is enough room for ventilation.

4. Conﬁrm that AC power and Ethernet access are available.

5. Inspect the recommended LibraPlus location to determine the following:

• the mounting structure is suitable;

• LOS and Fresnel Zone clearances can be met, because of OFDMs superior Non Line of Sight

performance these requirements will not be as stringent as for other systems;

• location of the LibraPlus is acceptable.

6. Check cable routes and entry and exit points to ensure that they are practical.

3.4.2. Tools and equipment

You will require the following tools and equipment

• Standard tool kit

• Test equipment

• Drill and bits

• LibraPlus Unit

• Weatherprooﬁng materials

• LibraPlus mounting hardware

• Ladder

• Cables: Outdoor CAT-5 Cable, AC power cable.

Field Installation