User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 5:3 Surge Suppressor Sides
5.4.4 Surge Suppression Unit Location
Lightning arrestors and surge protectors should be installed at all input/ output points
on the LibraPlus equipment. Additionally, they should be properly grounded by
connecting the body of the arrestor or protector to the grounding system with a heavy
gauge (6 AWG) copper wire. This grounding wire should be as short as possible.
The following figures illustrate the locations where the surge suppressors must be
installed, when cabling a LibraPlus 5860.
LibraPlus 5860 User Guide Pre-installation: Grounding Page 24 of 95