User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 6:3 Mounted for Vertical Polarization
Figure 6:4 Mounted for Horizontal Polarization
6.5
Pole-mounting the LibraPlus
Your next task is to install the unit. Before you begin, review the material in the Pre-
installation chapter of this manual and make certain that you have met all of the
conditions laid out there. Also, you should make certain that all of the necessary
brackets and bolts are included in the box with your unit.
To mount your LibraPlus unit on a pole:
1. Mount the LibraPlus Radio on the pole.
1.1. Mount the bracket clamp to the pole, as shown in the f igure below. I f the
pole is two (2) inches (5.08 cm) in diameter or less, turn the mounting
bracket clamp back over so that the angle faces the pole. This will allow
you to mount the bracket to a smaller pole.
LibraPlus 5860 User Guide LibraPlus I nstallation: Pole-mounting the LibraPlus Page 30 of 95